2. Adjust the mounting tree to a very stable point.

3. Turn the flute head down and insert the threaded shaft of the crown into the hole in the mounting tree.

4. The flute head should be held on both sides with both hands and pressed down firmly. Spare the mouth, just hold the tube! This allows you to extend the factory tuning plug. Take care of your physical integrity!

5. Insert the tuning plug into the flute head. The end marked with a red dot has a smaller diameter than the side marked with a black dot!!
The red mark should be placed on the left side, towards the crown plug,  the black mark on the right side. This is the only way it goes in!

6. Push in the tuning plug until the line on the mounting tree reaches the center of the air inlet..

7. Insert the crown plug into the end of the flute head. We recommend that you turn the crown plug slightly to the side and press the black rubber ring slightly. The corona plug should be firmly inserted into the flute head.

8. The package will include black spare rubber rings. If one of the rubber rings is too large to fit, it should be replaced with a thinner rubber ring.